Table of Contents
Advertisement
Installation Manual – RPSP
If the operation has been performed correctly, the
D14 LED will light up on the board.
Take the remote control (TX module) to the
maximum distance desired and push any of the
commands, ascend or descend (the D14 led will
switch off).
Fig. 49 – Press any command to calibrate the maximum operating distance.
When the procedure is complete put the dip
switches back in their original position on the
receiver (the position must be the same as the
transmitters, in the absence of other nearby
systems the standard configuration is with both
in the OFF position).
The set distance will be indicative as the radio
system
changes
environmental conditions change.
4.4.3 Onboard Alarm
This is situated inside of the body of the machine and
has been pre-installed in the factory by connector E
Fig. 48 – Switching ON of D14.
its
behaviour
when
Fig. 50 – standard configuration
Fig. 51 – Onboard Alarm Connector
LED D14
the
37
INS-RPSP-EN-05
OFF
Advertisement
Table of Contents
