Electromechanical Stop-Clutch Adjustment - Access RPSP Installation Manual

Installation Manual – RPSP
3. Using the two ferrules, adjust the position of the safety
rail arms, setting them at an upward inclination of 1°-
2° compared to the horizontal.
4. Perform the adjustment and tighten the ferrules with a
punch.

5.5 Electromechanical stop-clutch adjustment

Adjustment of the REB clutch enables the opening and the closing of the safety rail arms avoiding
possible overloads on the actuator which may occur in the following cases:
 The safety rail arm encounters an obstacle during movement.
 The safety rail arm is moved manually by the user.
Once the safety bar inclination angle has been adjusted,
adjust the clutch as follows:
1. Tighten the clutch bolt as necessary to enable the
actuators to move the rail safety arms.
Fig. 62 – Adjusting rail arm alignment
Fig. 63 – Clutch adjustment check
45
INS-RPSP-EN-05
2
2