Installation Manual – RPSP
Place the guide on the wall in the
correct position and begin to fix the
ground mountings.
Tip: the shortest stanchion (the one that comes down low) can be moved a few centimeters with
respect to the position shown on the drawing, to prevent the interference with the end-run cam.
Caution! Only install the main part of the guide, the closure casing will be installed later (and in any
case only after the inclined platform lift has been put on the guide).
Caution! Before fixing the mountings to the floor permanently, check with a level that each
stanchion is vertical.
Tip: first apply the dowels on the wall side (Fig. 21), check that the stanchion is vertical and then
apply the dowels on the lower part. Use pegs if necessary.
Caution! Due to the lack of space between the fixed and mobile parts of the machine, the use of
anchoring systems not approved by and supplied by the manufacturer is prohibited.
Fig. 21 – Fixing the stanchion to the ground
21
INS-RPSP-EN-05