Table of Contents
Advertisement
Installation Manual – RPSP
Special configurations
Every time the machine is powered, the mainboard emits a few acoustic signals to identify the set
configuration. Below you can find a table of possible configurations. These configurations can be changed
during installation using one or more configuration wirings ("tools").
Warning! The machine leaves the factory already configured. Modify this configuration only when
necessary and contact technical support assessing the possible introduction of risks to the system.
LED
The Mainboard is equipped with various LEDs that signal the
lift's status.
Please refer to the electrical diagram for detailed
information.
LED
LD1
LD2
LD3
LD4
LD5
LD6
LD7
LD8
LD9
LD10
LD11
LD12
LD13
BEEPS
Fig. 42 – Mainboard LEDs
DESCENT MOVEMENT (VERIFIED DESCENT SAFETY CHAIN )
ASCENT MOVEMENT (VERIFIED DESCENT SAFETY CHAIN )
PLATFORM ACTUATOR ACTIVATION
Table 1 – Mainboard LEDs
BEEPS
3 LONG+
LONG SIDE ACCESS ENABLED
2 SHORT
1 LONG+
LONG SIDE ACCESS DISABLED
2 SHORT
5 LONG+
LONG SIDE ACCESS ENABLED (with
2 SHORT
minimum encumbrance)
FUNCTION
+24VDC
ENABLE MOVEMENT
OVERRUN
HORIZONTAL SAFETY BARS
HORIZONTAL PLATFORM
DOWN COMMAND
UP COMMAND
GROUND FLOOR LIFT
HIGH FLOOR LIFT
LMS ACTUATOR ACTIVATION
34
INS-RPSP-EN-05
CONFIGURAZIONE
Advertisement
Table of Contents
