Installation Manual – RPSP
4.1.4 Special anchor bolts
Special anchor bolts can be supplied in addition to or in place of other previously mentioned bolts.
Instructions for each type will be supplied as necessary.
4.1.5 Rail junction
Insert the pins into the 2 holes upside and
downside on the same extremity of the rail to be
joined. Insert the pins by the means of a mallet.
The milled part of the surface has to be hidden
inside the guide as shown on the following figure.
Once the pins are inserted, connect the 2 points
of the guide one each other by two brackets and
the countersunk head screws provided.
Important - Safety: at the end of the installation, and after having verified the correct mounting of
the rail, apply extra-strong thread locker on the screw threads and re-fasten them.
Fig. 24 – Rail joint diagram
24
INS-RPSP-EN-05