Access RPSP Installation Manual page 31

Installation Manual – RPSP
 The moveable part of the guide must have a
special 4mm external diameter pin for joining.
 Insert the pin as shown in the figure. The
knurled part of the pin must disappear inside its
housing.
 With the special starter unit in the INSTALLATION KIT power the electric motor and move the traction unit
until it reaches the lower part of the track (level with the bottom stop).
Caution! Make sure the chain does not fold and that it is taut during the descent phase.
 At this point the other piece of the moveable
casing can be inserted so as to complete the
guide closure.
Caution! If the traction unit is too high you will not be able to insert the other moveable casing.
Fig. 34 - Detail of pin assembly on guide casing
Fig. 35
30
INS-RPSP-EN-05