Access RPSP Installation Manual page 29

Installation Manual – RPSP
 Slowly place the unit to the ground with the rear
cover touching the floor taking care not to damage
the parts.
 Staying in the front part of the machine (platform
side), disconnect the Motor Unit from the Frame,
unscrewing the 12 M8 screws after having
disconnected the motor cable that goes from main
terminal board M1 and connector X3 from the
connectors panel (see Electrical connections
layout).
 Unscrew the 2 M8 locknuts (placed on the top,
near the bottom of the safety bars) using a rubber
mallet (if necessary) to separate the two pieces
between them.
 The Drive Unit at this point is separated from the
Chassis and can be lifted. The proper sequence
is shown in figure
Fig. 29
Fig. 30
Fig. 31
28
INS-RPSP-EN-05