Installation Manual – RPSP
5.4 Safety bar levelling adjustment
After having levelled the platform, (the platform closing
angle may be set at 89° for every size platform following
the methods described in the installation manual), open it
and verify that both safety rail arms are aligned with 1°-2°
of upwards slope.
In the event that this is not the case, follow the indications
below to perform the adjustment:
1. Make sure that the actuator stem is at zero stroke.
2. Loosen the clutch bolt (1) until the actuator slides
freely along the rod.
Fig. 60 – Adjusting rail arm alignment
Fig. 61 – Adjusting rail arm alignment
44
INS-RPSP-EN-05
ALIGNED
NOT ALIGNED
INEATO
1