2.6 Blade and Blade Holder Installation
2.6.1 Blade Installation
Figure 2-20 is the illustrator of the blade holder. Insert a blade into the bottom of the blade
holder and remove the blade by pushing the pin. Make sure that your fingers are away
from the blade tip.
Adjustment depth knob
Outward ring
Step 1
Install blade (Figure 2-21).
Figure 2-21
Step 2
Push the blade to the bottom of the blade holder. (Figure 2-22).
Step 3
Adjust the blade tip to suitable length by screwing "Blade tip adjustment screw" clockwise
or count-clockwise. (Figure 2-23).
Figure 2-23
Installation
Pin
Figure 2-20
Figure 2-22
Tips:
"The proper length" means the blade's length is
adjusted 0.1mm more than film's thickness. That
is, if the thickness of film is 0.5mm, then blade's
length is properly adjusted 0.6mm and it can
completely cut through the film layer yet avoid
penetrating the backing.
2-13
RX II Series User Manual