GCC Technologies RX II Series User Manual page 34

RX II Series User Manual
Step 5 Please make sure the cutting plotter is powered on and connected to theUSB
device, and then click OK to next step.
Step 6 Confirm to close all running application programs before you start installing
the driver, and then click OK.
Step 7 The installation will take a few minutes to complete and you will see a
message below and click on "OK" upon completion. Enjoy your GCC cutter!
Step 8 If you want to install AASII VBA on CorelDRAW and Adobe Illusatrator, exit
CorelDRAW and Adobe Illusatrator program, and then click on"Install."
Installation
2-21