GCC Technologies RX II Series User Manual page 75

Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Factory Default? To turn all parameters of the menu items to factory-default
settings.
Auto Unrolled To avoid paper jam and motor crash by automatically unroll
Media media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
Auto Unrolled When "auto unrolled media" is enabled, user can adjust the
Length unrolled media length.
Auto Unrolled To adjust the unrolled media speed.
Speed
Rear Paper To detect if the rear paper sensor is covered to determine the
Sensor following process; when it is enabled, the cutter will detect if
the material has covered the rear paper sensor under the Roll
and Edge mode; when disabled, the rear paper sensor will
not be functioning.
Note: Rear paper sensor only functions under "Roll" and
"Edge" mode.
AAS detect
To recognize the printed sheet media is fed in forward
mode
direction or reversed direction by detecting the registration
marks.
1. Forward direction: to detect the registration marks in
forward media feeding direction
2. Auto detection: to distinguish the media feeding direction
automatically by by detecting the registration marks.
3. Reverse direction: to detect the registration marks in
reversed media feeding direction
Vacuum To help improve tracking and cutting accuracy by turning on
the fans. If you turn off the vacuum system, the fans
will remain inactive during cutting or plotting.
First Back to To enable the carriage back to the previous origin; when
Origin
"Enable" is selected, the carriage will not go back to the
previous origin while the selection of "Disable" allows the
carriage to do so.
AAS Copy
To enable the AAS copy. When "Enable" is selected, the AAS
module will continue to read the registration mark to contour
cut. Users can set distance between images and AAS copy
times in this function. The range of distance is 0-500mm, and
the range of times is 0-1000.
AAS Offset/ To set or modify AAS offset value.
You can refer to "5.3 Printer Test" for more details.
AAS Ext. Offset
Adjust the offset value under AAS Offset menu when a
regular blade holder is installed; adjust the offset value under
AAS Ext. Offset menu when an extension holder is installed.
Paper Saving To save media by four different modes:
Mode 1. Length expanded mode
3. Both expanded mode
The Control Panel
[ MISC ]
2. Width expanded mode
4. Both unexpanded mode
3-9
RX II Series User Manual
Enabled
500~3000mm 3000mm
Slow, Normal, Normal
Fast
Enable Enable
Disable
Enable, Disable Enable
Enable Enable
Disable
Enable Enable
Disable
AAS Offset: X:0,
Y:0
AAS Ext. Offset:
X:8.5, Y:3
Length
expanded
mode