RX II Series User Manual
Please pay attention to the direction of the base beam (the wheel on the front end of the
beam comes with a break while the rear one is on its own).
Front
Rear
Figure 2-3
Step 3
2
Place the stand beam upright on the T-stand and follow number
to assemble (See
Figure 2-4 & 2-5). There is hexagon socket head screws fasten on the T-stand on both
side taken as locating pins.
T-Stand
Stand beam
Figure 2-4
Figure 2-5
Step 4
Position the stand beam perpendicularly to part
and put the screws into the holes and
tighten them as Figure 2-5. Then the complete picture of stand will be like Figure 2-4.
Installation
2-3