Automatic Blade Length Detection - GCC Technologies RX II Series User Manual

2.7 Automatic Blade Length Detection

Figure 2.-26 is the new blade holder with a scale and the carriage with a mark. This blade
holder detects blade length automatically and shows how the knob needs to be turned on
the LCM.
Scale
Figure 2-26
There are 10 units on the scale; each unit equals to 0.05 mm, allowing you to adjust the blade
length for 0.00mm-5.00mm (Figure 2-27).
Follow the steps below to adjust the length of the blade:
1. Keep the blade tip within the blade holder before you start adjusting.
2. Align one of the scales on the blade holder to the mark on the carriage
3. Select "Blade Length Adjust" under "CUT TEST" on the LCM, enter the blade length
wished in "Set Length"; test the blade holder first and then test the blade length by
pressing ENTER.
Note: Keep the blade holder at the same position when you perform blade holder and
blade length tests.
Installation
1 unit
Mark
2-17
RX II Series User Manual
Figure 2-27