GCC Technologies RX II Series User Manual page 27

2.6.2 Blade Holder Installation
Step 1
Insert the blade holder into tool carriage. Please note the outward ring of the holder must
put into the grooves of carriage firmly (see Figure 2-24), then fasten the case (Figure
2-25).
Figure 2-24
Step 2
Use the reversing steps to remove the blade holder.
Step 3
Eject the blade. Push "Blade eject pin" to eject blade when the blade needs to be
replaced.
Caution!!
The blade will lose its sharpness after a period of usage; the cutting quality might be
affected. By increasing the cutting force, it might do the trick. However, once the
blade is worn out and no longer provides a reliable cutting, you should replace a
new one. The blade is consumable and must be replaced as often as necessary to
maintain the cutting quality. The quality of the blade deeply affects cutting quality. So
be sure to use a high quality blade to ensure good cutting results.
Installation
2-14
RX II Series User Manual
Figure 2-25