GCC Technologies RX II Series User Manual page 108

Step 2 Placing the Registration Marks

The AAS Layout Instruction:
* Auto-detection function on the 1
Suggested 30mm margin on both left and right sides of media sheet.

Suggested 20~30mm margin on top of media sheet, and at least 50mm margin on

the bottom edge to prevent sheets dropping or any error occurred while media sizing.
Step 3 Print the Graphics
■ Print the graphic and the marks with your printer
■ When printing on a roll media, make sure the orientation as following:
Automatic-Aligning System
st
mark covers the grey area
(Scaling = 100%).
5-9
RX II series User Manual