Table of Contents
Advertisement
4.4
How to Cut 3mm Letters
To obtain good quality output, narrow media is recommended. However, if wide media is used,
you should:
1.
Position two pinch rollers as close as possible to both edges of the cutting area.
2.
Make sure the loaded media is held flat with equal tension across the platen.
3.
Suggested operation settings:
4.5
How to Make a Long Plot
When you are making a long plot with a roll of heavy and wide vinyl, paper you need to use the
"AUTO UNROLL MEDIA" function. The following parameter settings are to help users get the
best cutting quality. The actual output quality may vary when using different kind of materials
1. If the length of graphic is between 3m and 5m, the cutting speed is
better slower than 72cm/sec and the cutting quality is set as Normal.
2. If the length is longer than 5m or if the material type is difficult to cut, it is
better to further slow down the cutting speed.
3. After loading the roll media all pinch rollers are raised at this stage,
flatten the media on the platen and hold the front edge of the roll media
firmly (Figure 4-15).
Operation
Tool force: 55 gf. (or depending on the material)
Cutting speed: 45-50 cm/sec
Tool up speed: 45-60 cm/sec
Smooth cut: Disable
Quality: Small Letter
Figure 4-15
4-8
RX II Series User Manual
Advertisement
Table of Contents
