2.8.2 RS-232 Interface
Connecting to the RS-232 (Serial) Port
1. For IBM PC, PS/2 users or compatibles, connect the RS-232C cable to the serial
connector of the assigned serial port (COM1 or COM2) of your host computer.
2. Set up the communication parameters (Baud Rate and Data Bits/Parity) to match
the setting of software package, refer to chapter 3 – "MISC" key description.
Caution!! Please turn off the plotter before plugging the RS-232C cable.
2.8.3 Ethernet Connection
I. Networking Connectivity Setup
Step 1
Connect the LAN port and Ethernet port on GCC cutting plotter with RJ45
Ethernet cable, and turn on the machine.
Installation
2-26
RX II Series User Manual