Menu In Off-Line Mode - GCC Technologies RX II Series User Manual

3.3 Menu in Off-line Mode

Offline For System Setup
[ ]
[ SPEED ]
[ FORCE]
[ OFFSET ]
[ DATA CLEAR ]
[CUT TEST ]
[CUT OFF]
The Control Panel
move origin M
X: Y:
Speed: 72 cm/s
Select: OK: ENTER
AAS Speed: Medium
Select: OK: ENTER
Quality: Normal
Select: OK: ENTER
Up Accel.: Medium
Select: OK: ENTER
UP Speed: 72 cm/s
Select: OK: ENTER
Force:80 gf
OK: ENTER
Offset: 0.275 mm
OK: ENTER
Clear Data Memory
N:ONLINE OK:ENTER
Square Cut
Select: OK:ENTER
Redo Jobs in Memory
Select: OK:ENTER
After sending AAS job
Repeat AAS Job
Select: OK:ENTER
Blade Length Adjust
Select: OK:ENTER
Ratio Setting
Select: OK:ENTER
Pattern Setting
Select: OK:ENTER
Cut off Paper
Select: OK:ENTER
Cut off Type
Select: OK:ENTER
RX II Series User Manual
Speed: 3~153 with an increment of 3 (cm/s)
High, Medium, Low
Draft, Fair, Normal, Fine, Small Letter
High, Medium, Low
Speed: 3~153 with an increment of 3 (cm/s)
5~600 with an increment of 5 (gram force)
0.000~1.000 with an increment of 0.025 (mm)
Recut #1
Select: OK:ENTER
Copy #1
Select: OK:ENTER
Set Length 0.00mm
Change: OK: ENTER
Ratio: 100%, 200%, 300%, 400%
Ratio:
Change: OK: ENTER
Pattern: Arrow
Change: OK: ENTER
Blade Holder Cut Off
Select: OK:ENTER
Auto Cut Off System
Select: OK:ENTER
3-4
Recut number: 0-99
Copy number: 1-999
Test Blade Holder
OK: ENTER
Test Blade Length
OK: ENTER
Turn CW
N:ONLINE OK: ENTER
Adjustment completes
OK: ENTER
100%
Pattern: Cross, Arrow
Force: 200g
Speed: 40mm/s
O Turn