GCC Technologies RX II Series User Manual page 15

Whether manual or electric screwdriver, be careful not to use excess torque force when
tightening or loosing screws. When tightening or loosing iron and stainless steel screws,
please refer to the following screw torque standard table, other materials screws are not
included.
diameter
2.2 Stand & Flexible Media Support System (for RX II-101S/132S/183S)
Step 1
Please examine supplied items in the accessory box of stand carton:
2 pieces of base beams

2 pieces of side beams

1 piece of stand beam

20 pieces of M6 screws

1 piece of M5 L-shape hexagon screw driver

1 piece of Installation Guide for Stand Set

Step 2
Remove the plotter body and the accessories from the shipped carton.

Assemble the base beam to the side beam with 2 screws to form a T-shape stand.

(See Figure 2-1)
Installation
Screw
Torque standard for high hardness materials
M3
M4
M5
M6
Torque value (kgf-cm)
6
16
30
50
Figure 2-1
2-2
RX II Series User Manual