Step 8
Complete the Number in X/Y (the number of copies desired on the X/Y axis) and
Distance in X/Y (distance between each copy) settings then click OK. Confirm that the
value of Distance in X/Y must be the same with step 6.
Note: The spacing of vertical & horizontal (Offset X & Y) should be ≥ 20mm or = 0mm; users are
advised to set the Distance in X/Y as 0 mm to remove the space between each copy to
avoid the waste of materials.
Step 9
The system will create several copies of the object with registration marks as shown in
the picture below.
GreatCut Plug-In
A-6
RX II User Manual