GCC Technologies RX II Series User Manual page 42

Step 4 Input the IP address you had acquired from the control panel to the TCP/IP. Click
OK to complete settings.
Step 5 Go to Output under File to check the settings.
Complete the driver installation process and your GCC Cutting Plotter is now allowed to
network.
Note: If you want to add new local device, please go to Output Devices under Settings,
and press the button on the right of Current Output Device and select Add local
device (if the device has been installed but you wanted to output through another
device, please select Change to set the IP address of another device).
Installation
2-29
RX II Series User Manual