Blade Installation - GCC Technologies Expert 52 User Manual

2.3 Blade Installation

Figure 2-7 is the illustrator of the blade
holder. Insert a blade into the bottom of
the blade holder and remove the blade by
pushing the pin. Make sure that your fingers
are away from the blade tip.
Step 1
Install blade (Figure 2-8).
Figure 2-8
Step 3
Adjust the blade tip to suitable length by
screwing "Blade tip adjustment screw"
clockwise or count-clockwise. (Figure 2-10).
Figure 2-10
Installation
Adjustment depth knob
Outward ring
Step 2
Push the blade to the bottom of the blade
holder (Figure 2-9).
Figure 2-9
Tips:
"The proper length" means the blade's
length is adjusted 0.1mm more than film's
thickness. That is, if the thickness of film is
0.5mm, then blade's length is properly
adjusted 0.6mm and it can completely cut
through the film layer yet avoid penetrating
the backing.
2-7
Expert 52 User Manual
Pin
Figure 2-7