GCC Technologies RX II Series User Manual page 71

Offline For System Setup
[ TOOL SELECT]
[ MISC]
The Control Panel
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Factory Default ?
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Auto Unrolled Length
Select: OK:ENTER
Auto Unrolled Speed
Select: OK:ENTER
Rear Paper Sensor
Select: OK:ENTER
AAS detect mode
Select: OK:ENTER
Vacuum
Select: OK:ENTER
First Back To Origin
Select: OK:ENTER
AAS Copy
Select: OK:ENTER
AAS Offset
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Set communication
Select: OK:ENTER
Firmware x.x.xx
FPGA: xx.xx
Sizing Setting
Select: OK:ENTER
Select Language
Select: OK:ENTER
3-5
RX II Series User Manual
Select from 1S to 4S
OverCut: 0.00~1.00mm with an
increment of 0.05mm
Pouncing: 0~200mm with an
increment of 1mm
Cancel Restore
Change: OK: ENTER
Sure to Restore
Change: OK: ENTER
Enabled, Disabled
Unrolled 500~3000mm
Slow, Normal, Fast
Enabled, Disabled
Auto detection, Reverse direction, Forward direction
Enabled, Disabled
Enabled, Disabled
Enabled, Disabled
AAS Ext. Offset
Select: OK:ENTER
Both Expanded Mode, Length Expanded Mode,
Width Expanded Mode, Both Un
USER Defined, Default EDGE, Default ROLL
English, Francais, Türkce, Polski, Japanese, Deutsch,
Italian, Espanol
X, Y:
-10.000~10.0
00
e
xpanded Mode,