RX II Series User Manual
Step 3
Position the Desktop Support Brackets beside the Roll Holder Support and insert M6
screws into the Roll Holder Support and tighten them with M6 L-shape screw driver.
(Refer to Figure 2-14).
Step 4
Put the bottom of machine in lateral, and position the Roll Holder Assembly beside the
bottom of the machine. Then, insert the M6 screws into the holes of Roll Holder support
assembly and tighten them with M6 L-shape screwdriver. Like Figure 2-15.
M6 screws
Screw holes
Roll Holder Assembly
Roll Holders
Figure 2-16
Figure 2-15
Step 5
Place the two roll holders into the holes of Roll Holder Support (Figure 2-16).
Step 6
The complete Desktop Media Support System will be shown as in Figure 2-17.
Figure 2-17
Installation
2-11