Removal And Installation Of Tool Carriage - GCC Technologies Puma Series Maintenance Manual

Removal and installation of Tool Carriage

Refer to Fig 1-4 and following steps to remove the Tool Carriage.
Step 1. Remove the Top Cover.
Step 2. Unplug the Flat Cable from Carriage PCB.
Step 3. Remove the Carriage Cover (Push down the cover's top, then pull it downward).
Step 4. Loosen the screws of the Small Roller (lower) about 2~3 revolutions to release the Carriage.
Step 5. Unscrew both DU rollers and remove them.
Step6. To remove the Tool Carriage, tilt and pull down. Be careful not to damage the Carriage PCB.
Carriage Cover
Carriage PCB
Carriage Guide Beam
Blade Holder Screw
Fig 1-4
DU roller
Small Roller
28