Huawei SmartDC V100R021C10 User Manual page 47

ECC800 Data Center Controller
User Manual
Specifications
Table 3-28 Access actuator technical specifications
Item
Power input
PoE port
Wireless
communicati
on
AI/DI port
DO/DI port
RS485 serial
port
expansion
Wiegand port
BLINK button
Address DIP
switch
E-label
Indicators
Table 3-29 Access actuator indicators
Indicator
PWR
Issue 04 (2021-10-09)
Specifications
● DC input: terminal, with an input voltage of 36 V DC–60 V
DC
● PoE power supply: one PoE port that complies with
IEEE802.3at
FE communication with the rate of 10/100 Mbit/s
One wireless communication port that complies with IEEE
802.15.4, mutual backup with FE communication
Two AI/DI ports, can connect to the fire alarm and exit button
● One 12 V DC power output that controls magnetic locks,
terminal
● One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communication
rate of 9600 bit/s, physical port cascading supported (reserved
function)
Two Wiegand ports, 12 V DC card reader operating power
output; two routes of card readers can operate at the same
time.
● Press the button for less than 1 second to start blinking.
● Hold down the button for 1–5 seconds to search for a
network and start networking.
● Hold down the button for more than 10 seconds to clear
network parameters.
4-pin address DIP switch
Supported
Color Name
Green Power input
status
indicator
Copyright © Huawei Technologies Co., Ltd.
Status
● Steady on: The power input is normal.
● Off: There is no power input.
3 Device Description
35