Huawei SmartDC V100R021C10 User Manual page 59

ECC800 Data Center Controller
User Manual
Indicators
Table 3-40 Indicators
Indicator
Power
RUN
ALM
RF_Z
Issue 04 (2021-10-09)
Color Name
Green Power input
status
indicator
Green Running
status
indicator
Red Alarm
indicator
Green Communicati
on status
indicator
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power input is normal.
Off There is no power input.
Off The power is abnormal or
the board program is
loading.
Blinking at The smart module actuator
long successfully registers with
intervals the ECC800-Pro and the
software runs properly (the
indicator blinks at 0.5 Hz, on
for 1s and then off for 1s).
Blinking at The communication fails or
short the smart module actuator
intervals fails to register with the
ECC800-Pro (the indicator
blinks at 4 Hz, on for 0.125s
and then off for 0.125s).
Blinking The indicator blinks at super
short intervals for 0.5s
(blinking at 10 Hz, on for
0.05s and then off for 0.05s)
and then turns off for 0.5s.
The cycle lasts for 5s.
Steady on A system failure alarm is
generated.
Off No system alarm is
generated.
Steady on No network parameters
exist, or a network is to be
created.
Blinking at A network is set up, and no
long node access is allowed (the
intervals indicator blinks at 0.5 Hz, on
for 1s and then off for 1s).
Blinking at A network is being set up,
super short and node access is allowed
intervals (the indicator blinks at 10
Hz, on for 0.05s and then off
for 0.05s).
3 Device Description
47