Huawei SmartDC V100R021C10 User Manual page 361

ECC800 Data Center Controller
User Manual
Address
4
Step 2 Add a T/H sensor.
1.
2.
3.
Step 3 Check functions of the T/H sensor.
Table 8-37 Function commissioning
Check Method
Check the running
information about the T/H
sensor on the WebUI.
Issue 04 (2021-10-09)
Toggle
Switch 1
OFF
Log in to the ECC800-Pro WebUI as an administrator.
Add a T/H sensor.
Table 8-36 Adding a T/H sensor
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
Communica
for adding
tions Port
devices are
displayed.
Device
Address
Click Test Connect to check whether the T/H sensor connects to the ECC800-
Pro properly.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 2 Switch 3
OFF ON
Setting
Select Sensor from the drop-down list box.
Select T/H sensor from the drop-down list
box.
Select ECC800 from the drop-down list box.
Select COM3 from the drop-down list box.
NOTE
The setting example indicates that the T/H sensor
is connected to the COM3 port on the ECC800-
Pro. If the T/H sensor is connected to another
port, select the number of the connected port.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the T/H sensor based on the
actual situation.
Normal Connection Status
Choose Monitoring > Aisle > T/H Sensor Group
> T/H Sensorn > Running Info, and check the
current T/H information of the cabinet.
Toggle Toggle
Switch 4 Switch 5
OFF OFF
8 FAQ
Toggle
Switch 6
OFF
349