Commissioning Cabinet Electronic Clasp Locks - Huawei SmartDC V100R021C10 User Manual

ECC800 Data Center Controller
User Manual
3.
----End

5.9 Commissioning Cabinet Electronic Clasp Locks

If a cabinet electronic clasp lock is installed, perform the following steps to
configure it.
Prerequisites
●
●
●
Procedure
Step 1 (Optional) Check whether the cabinet door lock is leveled to 2000 (+3) mm. If
not, adjust it.
Step 2 (Optional) If the cabinet door still cannot be opened after step 1 is performed,
adjust the position of the cabinet electronic clasp lock by using the slotted holes
until the cabinet door can be opened and closed properly.
Issue 04 (2021-10-09)
Path Parameter
Settings > Device Type
Device
Management
and click Add
Connect To
Device. The
parameters for
adding devices
are displayed.
Communicat
ions Port
Device
Address
Click Test Connect to check whether the PDU2000 connects to the ECC800-
Pro properly.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the cable is properly connected to
the device, whether the device is running properly, and whether the
parameter settings are consistent with the device parameters.
COM1–COM3 on the ECC800-Pro are connected to cabinet electronic clasp
locks.
The smart module view has been deployed. The layout type is single-row
view.
The cabinet door can be opened and closed properly. If the cabinet door
cannot be opened and closed properly, adjust the position of the cabinet
electronic clasp lock by performing steps 1 and 2.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Setting
Select PDU2000-M (C) or PDU2000-M (H)
from the drop-down list box based on the
actual device.
Select ETH Converter1 from the drop-
down list box.
NOTE
In this example, the PDU2000 is connected to
ETH converter 1.
COM1/COM2
Enter the actual device address of the
PDU2000.
123