Huawei SmartDC V100R021C10 User Manual page 150

ECC800 Data Center Controller
User Manual
3.
4.
5.
Issue 04 (2021-10-09)
NO TE
The following describes how to set the access actuator.
Figure 6-3 Setting the authentication mode
NO TE
– If the access actuator version is V139 or later, the access actuator supports the
authentication mode by card, password, or fingerprint.
To query the access actuator version, choose Maintenance > Version Information.
View the version in the Device Version list.
– If you set the authorization mode to Combination, for example, Card, password
and fingerprint, you need to first swipe your card, enter the password, press the
pound key (#), and then enter the fingerprint. The door can be opened only after
verification of all the three items is successful.
– If you set the authorization mode to Card, password or fingerprint, when you use
the password to enable the access control, enter the password in the format of
user ID * password #. If you enter an incorrect password or user ID, press * on the
keyboard of the access controller to stop the authentication process. Then, enter
user ID * password #.
To query the user ID, log in to the ECC800-Pro WebUI as an administrator. Choose
System Settings > Access Management. In the Authorization area, view the user
ID corresponding to the user name.
Select the configured access actuator and click OK to complete setting the
authorization mode.
Click Add on the Authorization Operations tab page. The New User page is
displayed.
NO TE
The system supports a maximum of 1000 access users.
On the Basic Info tab page, enter User name and Employee ID.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
138