Huawei SmartDC V100R021C10 User Manual page 288

ECC800 Data Center Controller
User Manual
3.
Step 2 On the System Settings page, choose WiFi Networking and click Scan.
Figure 6-113 Scanning for hotspots
Step 3 After the scanning is complete, select the corresponding router based on the
hotspot signal in Scanning Result, set the IP address, Subnet mask, and Default
gateway parameters, ensure that the IP address of the ECC WiFi network is in the
same network segment as the IP address of the router, and click OK.
Issue 04 (2021-10-09)
Figure 6-112 WebUI login page
On the login page, enter the preset user name admin and preset password
Changeme, set the language, and click Log In.
NO TE
– After the first login, change the password in time to improve account security and
prevent unauthorized network attacks, such as data tampering. Huawei will not be
liable for any loss caused by your failure to change the password in time or to keep
the new password properly.
– You are advised to change the password periodically.
– Record and keep the password properly. If you forgot the password, you will be
unable to log in to the WebUI.
– When the event notification is configured and the password retrieval mode is
configured under user management, the password can be retrieved.
– An account is logged out due to a timeout if no operation is performed within 10
minutes after system login.
– A maximum of three users can log in to the ECC800-Pro WebUI at the same time.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
276