Rollover Sensor; Inspection; Removal - KYMCO AHG5 Service Manual

17. IGNITION SYSTEM

6. Rollover Sensor

6.1.

Inspection

Support the scooter level surface.
Put the side stand up and engine stop switch
on "RUN". Turn the ignition switch to "OFF".
 Do
not disconnect
connector during inspection.
 The capacity of battery must be fully
charged.
Up position resistance
Terminal
V/R(+)-G/P(-)
B/L(+)-G/P(-)
Fall down resistance
Incline the tilt switch 65±10 degrees to the
left or right at the ignition switch "ON".
Measure the voltage as below.
Terminal
V/R(+)-G/P(-)
B/L(+)-G/P(-)
 To repeat this test, first turn the
ignition switch to "OFF", then turn
the ignition switch to "ON".
6.2.

Removal

Disconnect the connector.
Remove the bolts to remove the sensor.
Install in the reverse order of work.
 Install the sensor with its "up" mark
facing up.
the sensor
Value
5V (ECU voltage)
0.4~1.4V
Value
5V (ECU voltage)
4~4.4V
17-7
DT X360