Wts Sensor - KYMCO X-Town 250 ABS Service Manual

13. FUEL INJECTION SYSTEM
WTS SENSOR (Water
Temperature Sensor)
REMOVAL / INSTALLATION
Drain the coolant from the cooling system.
Disconnect the WTS sensor connector from
the sensor.
Remove the WTS sensor and O-ring.
Install a new O-ring and WTS sensor.
＊
Always replace an O-ring with a new one.
one.
Tighten the WTS sensor to the specified
torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling
recommended coolant.
INSPECTION
Measure the resistance at the WTS sensor
terminals.
STANDARD
º C -20 40
KΩ
18.8 1.136
13-25
system with the
100
0.1553
X-Town250/300 ABS
O-ring