Wts Sensor - KYMCO Venox 250 Service Manual

19. AFI (AUTOMATIC FUEL INJECTION)

WTS SENSOR

REMOVAL /INSTALLATION
＊
Replace the WTS sensor while the engine is
cold.
Drain the coolant from the cooling system
Disconnect the WTS sensor connector from the
sensor.
Remove the WTS sensor and O-ring
Install the new O-ring and WTS sensor.
＊
Always replace an O-ring with a new one.
Tighten the WTS sensor to specified torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling system with the recommended
coolant
INSPECTION
Measure the resistance at the WTS sensor
terminals
STANDARD
ºC -20 40
KΩ 18.8 1.136
19-31
100
0.1553
WTS sensor
VENOX250/250i