Assembly - KYMCO AHG5 Service Manual

14. FRONT ASSEMBLY
DT X360
Remove the front wheel bearing by using
the special tool.
Special tool:
Bearing puller: A120E00037
Remove the distance collar from wheel.
3.4.

Assembly

Heat the bearing area of the wheel with a
heat gun, take the bearing out of the freezer
and install it. You can use a bearing installer
tool or a socket with the same outside
diameter as the bearing. Make sure the
bearing is fully seated and the marked side
is facing out.
Special tool:
Bearing installer A120E00014
Insert the distance collar into the hub.
Drive in the other bearing. The bearing
should fit against the distance collar.
Do not continue to force the bearing in or
the distance collar will begin to push the
right bearing back out.
Apply grease to the lips of the dust seals.
Drive in new dust seals.
14-8