Installation - KYMCO AHG5 Service Manual

4. LUBRICATION SYSTEM

4.5. Installation

Install the oil pump and oil pump and
tighten the two bolts.
 Make sure the pump shaft rotates
freely and arrow mark which is on
the oil pump is upside.
Install the pump drive chain and driven
sprocket, then set the snap ring securely
on the pump shaft.
Install the oil separator cover properly.
 Fit the tab of the pump cover into
the slit in the pump.
Oil Pump Bolts
Oil Pump Driven Sprocket
Bolts
4-9
DT X360
Oil Pump
Oil Snap Ring
Cover