Battery; Removal; Installation; Voltage Inspection - KYMCO AHG5 Service Manual

16. BATTERY/CHARGING SYSTEM

3. Battery

3.1.

Removal

The battery is in the front part of the vehicle.
1. Remove the wind screen and front
cover.
2. Remove the screws.
3. Remove the battery cover.
4. Disconnect the negative cable from the
battery first, and then disconnect the
positive cable.
5. Remove the battery from the battery
box.
3.2.

Installation

Install in the reverse order of the removal.
 When
install
connect the positive cable and then
negative cable
circuit.
3.3.

Voltage Inspection

Measure the battery voltage using a
commercially available digital multimeter.
Voltage :
Fully charged: 13－13.2 V
Under charged: below 12.3 V
the battery, first
to avoid short
Positive cable
Positive cable
16-5
DT X360
Negative cable
Negative
cable