KYMCO AHG5 Service Manual page 69

5. ENGINE
1. ENGINE REMOVAL/INSTALLATION
1.1. Removal
Remove the air cleaner.
Remove a bolt from fuel hose holder.
Disconnect the following connectors:
- Idle air bypass valve
- TPS
- WTS
- MAP
- Intake air pressure sensor
- O2 sensor
- Rectifier/ Regulator
- Fuel injector
- Thermostat
Remove the throttle cable.
Disconnect the fuel hose from fuel injector.
Remove the rubber cap on the starter motor
lead.
Remove the starter motor lead nut. Free the
cable lead from the starter motor. Thread the
nut back on to keep track of it.
Disconnect the ground wire.
Loosen the water pump hose clamp with a
#2 Phillips screwdriver. Slide up the clamp
and free the coolant hose from the water
pump. Allow any remaining coolant to drain
into a suitable container.
Squeeze the air bleed hose clamp with
needle nose pliers and slide back the clamp.
Free the air bleed hose from the thermostat.
WTS connector
Fuel injector
Air bleed hose
5-4
DT X360
Fuel hose holder
Ground wire
Coolant hose