Related Manuals for Cabletron Systems MMAC-Plus 9E423-24
Summary of Contents for Cabletron Systems MMAC-Plus 9E423-24
- Page 1 MMAC-Plus ™ Module Local Management 9E423-24 Module Specific Appendix DRAFT 9031671...
-
Page 2: Modifying Fields And User Privileges
Information Introduction This appendix contains local management information that is specific to the 9E423-24 Ethernet Switch Module. The 9E423-24 Ethernet Switch Module is a 25-port switching module with: • 24 front panel Ethernet ports (2 RJ-71 Telco connectors) • 1 Internal Network Bus (INB) backplane port Each front-panel port of the 9E423-24 can be configured to operate in the Full Duplex... -
Page 3: Module Interface Codes
9E423-24 Module Specific Information Module Interface Codes The 9E423-24 Ethernet Switch Module has 29 interfaces. The table below lists the identifying number, name, and description of each interface. Interface Number Table 1. 9E423-24 Module Interface Codes Interface Name SMB1 1 Mbps System Management Bus... - Page 4 Table 1. 9E423-24 Module Interface Codes Interface Interface Number Name ENET19 ENET20 ENET21 ENET22 ENET23 ENET24 Use the numbers listed in Table 1 to configure the module’s default interface (see the General Configuration Screen). Interface Description Ethernet Front Panel Port 19 Ethernet Front Panel Port 20 Ethernet Front Panel Port 21 Ethernet Front Panel Port 22...
- Page 5 9E423-24 Module Specific Information Full Duplex Configuration Screen The 9E423-24 Full Duplex Configuration Screen displays the port number, operation mode, link status, and port status of the module’s 24 ports (12 ports at a time). Module Name: 9E423-24 Slot Number: 12 PORT# SAVE MMAC-Plus...
-
Page 6: Full Duplex Configuration Screen Fields
Full Duplex Configuration Screen Fields OPERATION MODE (Modifiable) - This field lets you determine whether the specified port will transmit and receive data separately or simultaneously. You can set this field to one of the following values: • STANDARD ENET - The port can either transmit data or receive data, but not both at the same time. - Page 7 9E423-24 Module Specific Information PORT STATUS (Read-only) - Indicates whether the port has been turned on or off administratively. You will see one of the following values: • ENABLED - The port is turned on administratively. • DISABLED - The port is turned off administratively. Enable or disable ports from the Bridge Configuration screen.
-
Page 8: Port Statistics Screen
Port Statistics Screen The 9E423-24 Port Statistics Screen displays information and statistics about the module’s 24 Ethernet ports. Module Name: 9E423-24 Slot Number: 12 PACKETS: TOTAL ERRORS: COLLISIONS: CRC/ALIGNMENT ERRORS: UNDERSIZE PACKETS: OVERSIZE PACKETS: FRAGMENTS: JABBERS: BROADCASTS: MULTICASTS: PORT #: 1 MMAC-Plus Local Management PORT STATISTICS... - Page 9 9E423-24 Module Specific Information Port Statistics Screen Fields PORT # (Read-only) - Indicates the current port for which statistics are displayed. OCTETS (Read-only) - Displays the number of octets transmitted and received. PACKETS (Read-only) - Displays the number of packets transmitted and received. TOTAL ERRORS (Read-only) - Displays the total number of errors on this port.
- Page 10 PORT TYPE (Read-only) - Displays one of the following values: • • • EPIM-x • MMF SMA • MMF ST • RJ45 • RJ71 • SMF ST PORT STATUS (Read-only) - Indicates the administrative status of the selected port. Possible values are ENABLED and DISABLED. APPLICATION (Read-only) - Displays BRIDGING, indicating that the port is operating as a bridge with a high-speed backbone connection.