Ip Router To Ip Router Configuration; Configuration For Site "Central - Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual
Central site remote access switch
Hide thumbs
Also See for CyberSWITCH CSX5500:
- User manual (729 pages) ,
- User manual (178 pages) ,
- Release note (9 pages)
Table of Contents
Advertisement
QUICK START
4.
Under Security, select Device Level Databases, select On-node Device Entries, then add a device
where the Device Name (Central) must match the system name on Central. When you add the
device you must then enter the following information:
a.
Under ISDN Information make sure the ISDN Line Protocol is PPP.
b. Under ISDN Information you must enter a dial out number (13135551111) and a base data
rate (64Kb).
c.
Under Authentication you must:
•
Change CHAP Secret so that it matches Central's System secret (Central_S).
•
Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).
d. Under Bridging you must:
•
Make sure that Bridging is enabled
•
Make sure that Make calls for Bridge Data is enabled.
5.
Under Options, select Bridging, then select Bridge Dial Out. Make sure dial out is enabled. Then
add the device (Central) that you wish to call when you receive a ethernet packet that is not on
the same LAN as Remote. Note that the bridge dial out configuration is slightly different for
Remote than it was for Central.
IP R
IP R
OUTER TO
OUTER
CSX5500
Site IP Address 199.2.2.0
C
S
ONFIGURATION FOR
ITE
The configuration on Central to allow IP Routing to Remote using PPP is as follows:
1.
Perform
initial configuration
2.
Under Options, select Bridging, then disable Bridging. Select IP Routing, then:
a.
Enable IP Routing.
b. Under IP Interfaces add a LAN Interface (IP address 199.2.2.1).
c.
Under IP Interfaces add a WAN UnNumbered Interface.
3.
Under Security, select System Options and Information, then under System Information:
a.
Set your System Name (Central). This matches up with Central device information
configured on Remote.
b. Set your System Secret (Central_S). This matches up with Central device information
configured on Remote.
18
CyberSWITCH
C
ONFIGURATION
"Central"
LAN IP Address 199.2.2.1
Phone 13135551111
"C
"
ENTRAL
steps.
ISDN
"Remote"
LAN IP Address 201.1.2.1
Phone 13135552222
Site IP Address 201.1.2.0
CSX1200
WORKGROUP REMOTE ACCESS SWITCH
B-CHANNELS
E1 ONLY
LAN
POWER
SERVICE
TX
RX
10BASE-T
B1
B3
B5
B7
B9 B11
B13 B15
B17 B19
B21 B23
B25 B27
B29
B31
E1
T1
B2
B4
B6
B8
B10 B12
B14 B16
D
B18 B20
B22 B24
D
B26 B28
B30 L1
Advertisement
Table of Contents
