Warning Lamp Installation, 12Ft - Landoll Brillion SL10 Operator's Manual

ASSEMBLY

Warning Lamp Installation, 12FT

NOTE
12FT Drawbar model is shown, 3-PT models similar.
1. Attach both Red Lamps to the ends of the Light Bar
with 1/4-20 x 1-1/4 Bolts and Locknuts. See
Figure 2-17.
2. Attach longer Light Bracket to the Transmission
located on the left side of the Seeder, with 3/8-16 x
1-1/4 Bolts, Lock Washers and Nuts.
3. Attach Amber Lamp to the outside of the Light
Bracket with 1/4-20 x 1-1/4 Bolts and Locknuts.
4. On the right side of the Seeder, attach the shorter
Light Bracket to the Angle Bracket with 1/2-13 x 1-1/4
Bolts, Lock Washers and Nuts.
5. Attach an Amber Lamp to the upper portion of the
Light Bracket with 1/4-20 x 1-1/4 Bolts and Locknuts.
6. Attach the Light Module to the Module Bracket with
1/4-20 x 1-1/2 Bolts and Locknuts. See Figure 2-16.
7. Lay out the Lamp Harness, noting that the
connectors marked with Green Tape is Right Side
and Yellow Tape is Left Side.
8. Connect the Lamp Harness into the Light Module,
route the plugs with Green Tape along the front right
side of the frame. Route the 3 prong cord up the
Light Bar and plug into the Red Lamp. Continue
routing the 2 prong cord along the front of frame, up
the outer Light Bracket and plug it into the Amber
Lamp.
9. Repeat for the Left Side (Yellow Tape).
10. Connect the 7-Pin Harness into the Light Module,
then route the harness along the Drawbar with the
Hydraulic Hoses and secure with tie wraps.
11. Bundle and secure excess cord to the Module
Bracket with tie wraps. Secure cords along frame
and Drawbar using Adhesive Mounts and tie wraps.
NOTE
If equipped with optional Electrical Clutch, install, route
and secure Electric Clutch Harness with the Warning
Lamp Harness.
2-12
IMPORTANT
All Harnesses must be firmly attached to Machine
Frame members or Hydraulic Hoses so they do not
sag or become torn loose by field debris.
12. Attach the SMV sign to the SMV Mount located on
the center on the Light Bar with 5/16-18 x 1 Bolts,
Flat Washers, and Locknuts.
13. Attach the Connector Holder to the Drawbar Hose
Holder or 3-PT Hitch with 1/4-20 x 1 Bolts, Flat
Washers, and Locknuts.
NOTE
The 7-Pin Plug on the other end of the 7-Pin Harness
connects to the Tractor Socket when in use. When not in
use, it can be stored in the Connector Holder on the
Drawbar Hose Holder or 3-PT Hitch. Allow enough
Harness length to reach Tractor Socket and roll or fold up
excess and secure to Drawbar Hydraulic Hoses or 3-PT
Hitch.
Bolt,
1/4-20 x 1-1/2
Figure 2-16: Light Module and Bracket
Module Bracket
Locknut,1/4-20
Light Module
1P342-0621