Agitator Kit - Optional - Landoll Brillion SL10 Operator's Manual

ASSEMBLY

Agitator Kit - Optional

1. Remove knock-outs for 3/4" flangette bearings.
These are located at each end and center of Seed
Box assembly. Hole patterns are as shown below:
Figure 2-23: Hole Patterns
8FT Models - See Figure 2-25.
10FT Models - See Figure 2-26.
12FT Models - See Figure 2-27.
2. Install bearings and 1/4" thick spacer at left end of
Seed Box. Secure with three 5/16-18 x 1-1/2 Bolts,
Lock Washers and Nuts.
3. Install left end Shaft Agitator and 19 Tooth Sprocket:
8FT 3K436, 3/4 x 5-1/4" is a three hole pin.
10FT 1K197, 3/4 x 5-1/4" is a two hole pin.
12FT 1K197, 3/4 x 5-1/4" is a two hole pin.
End of shaft with the hole 3/4 inch from the end is for the
sprocket and slotted pin. Align sprocket with unused
lower sprocket already in transmission.
4. Install one of the agitators (they are all the same per
kit) on the left shaft. Secure with 1/4-20 x 1-1/2 Bolt
and Locknut.
5. Install one of the center shafts in the agitator from
Step 4.
6. Install the second agitator. Secure with 1/4-20 x 1-1/2
Bolt and Locknut.
7. Install center bearing and shaft. Secure center
bearing with three 5/16-18 x 1-1/2 Bolts, Lock
Washers and Nuts. Secure shaft with 1/4-20 x 1-1/2
Bolt and Locknut
8. Complete assembly in a similar manner for the right
hand box.
2-20
3/8" Diameter
2 3/16"
Diameter
9. Tighten locking collars in direction of rotation
(counter-clockwise when viewed from the right end of
machine).
10. Rotate agitator assembly to be sure it turns freely.
11. Install drive chain. Long ends of the connector pins
for both chains should point away from each other to
prevent interference.
12. Check chain tension bar to be sure it aligns very
closely with chain. Bend slightly if needed and install
using 3/8-16 x 1-1/4 Bolts, Flat Washers, Lock
Washers and Nuts. See Figure 2-24.
13. Adjust chain tension so both strands of chain are
nearly taut.
Figure 2-24: Chain Tension Bar
14. Install Seed Box dividers, secure with .187 x 3/16
rivets.
1P342-0621