Table of Contents
Advertisement
ASSEMBLY
Warning Lamp Installation, 8FT
and 10FT
NOTE
8FT 3-PT model is shown, 8FT Drawbar and 10FT 3-PT
and Drawbar models are similar. See Figure 2-15.
1. Attach longer Light Bracket to the Transmission
housing located on the left side of the seeder, with
3/8-16 x 1-1/4 Bolts, Lock Washers and Nuts.
2. Attach Amber Lamp to the upper portion of the longer
Light Bracket with 1/4-20 x 1-1/4 Bolts and Locknuts.
3. Attach a Red Lamp below the Amber Lamp using
1/4-20 x 1-1/4 Screws and Locknuts. Ensure Red
Lamp lenses faces rearward.
4. On the right side of the Seeder attach the shorter
Light Bracket to the Angle Bracket with 1/2-13 x 1-1/4
Bolts, Lock Washers and Nuts.
5. Attach Amber Lamp to the upper portion of the Light
Bracket with 1/4-20 x 1-1/4 Bolts and Locknuts.
6. Attach a Red Lamp below the Amber Lamp with
1/4-20 x 1-1/4 Bolts and Locknuts. Ensure Red Lamp
lenses faces rearward.
7. Attach the Light Module to the Module Bracket with
1/4-20 x 1-1/2 Bolts and Locknuts. See Figure 2-14.
8. Lay out the Lamp Harness, noting that the
connectors marked with Green Tape is Right Side
and Yellow Tape is Left Side.
9. Connect the Lamp Harness into the Light Module,
route the plugs with Green Tape along the front right
side of the frame up the outer Light Bracket and plug
the 2 prong cord into the Amber Lamp. Plug the 3
prong cord into the Red Lamp.
10. Repeat for the Left Side (Yellow Tape).
11. Connect the 7-Pin Harness into the Light Module,
then route the harness along the 3-PT Hitch.
12. Bundle and secure excess cord to the Module
Bracket with tie wraps. Secure cords along frame
and 3-PT Hitch using Adhesive Mounts and tie wraps
NOTE
If equipped with optional Electrical Clutch, install, route
and secure Electric Clutch Harness with the Warning
Lamp Harness.
2-10
IMPORTANT
All Harnesses must be firmly attached to Machine
Frame members or Hydraulic Hoses so they do not
sag or become torn loose by field debris.
13. Attach the SMV sign to the SMV Mount located on
the center on the Front Frame with 5/16-18 x 1 Bolts,
Flat Washers, and Locknuts.
14. Attach the Connector Holder to the 3-PT Hitch or
Drawbar Hose Holder with 1/4-20 x 1 Bolts, Flat
Washers, and Locknuts.
NOTE
The 7-Pin Plug on the other end of the 7-Pin Harness
connects to the Tractor Socket when in use. When not in
use, it can be stored in the Connector Holder on the
Drawbar Hose Holder or 3-PT Hitch. Allow enough
Harness length to reach Tractor Socket and roll or fold up
excess and secure to Drawbar Hydraulic Hoses or 3-PT
Hitch.
Bolt,
1/4-20 x 1-1/2
Figure 2-14: Light Module and Bracket
Module Bracket
Locknut,1/4-20
Light Module
1P342-0621
Hide quick links:
Advertisement
Table of Contents
