3-Pt Seeder Assembly - Landoll Brillion SL10 Operator's Manual

ASSEMBLY

3-PT Seeder Assembly

When shipped, seeder comes assembled except for
Lights and 3-PT Hitch.
1. Support Seeder Assembly with a hoist or by similar
means capable of supporting its weight without
tipping.
2. Center 3-PT Hitch Assembly in relationship with the
Seed Box Center Bracket. Attach 3-PT Hitch to
Seeder Frame Tube with 5/8-11 U-Bolts, Lock
Washers and Nuts. See Figure 2-5.
3. Install Manual Holder to 3-PT Hitch with Hose Clamps.
4. 8FT Seeders: Install SMV Mount to Seed Box Frame
with 1/2-13 U-Bolt, Lock Washers and Nuts. See
Figure 2-1.
10FT Seeders: Install SMV Mount to Seed Box
Center Bracket with 1/2-13 x 1-1/2 Bolts and
Locknuts. See Figure 2-2.
SMV Mount
Seed Box
Nut,1/2-13
Lock
Washer,1/2
Frame
Figure 2-1: SMV Mount, 8FT
Seed Box
SMV Mount
Bolt,
1/2-13 x 1-1/2
Figure 2-2: SMV Mount, 10FT
2-2
Do not disengage pin unless seeder is fully
attached to a tractor. Seeder may be rear-heavy
and tip backward on frame.
5. Be sure Parking Pin is locking Rear Roller down and
raise the Seeder. See Figure 2-3.
SMV
6. On the right side of the Seeder Frame, in a similar
position as the Parking Pin, remove the 5/8-11
Shipping Bolt that also locks the Rear Roller down.
See Figure 2-4.
U-Bolt,
1/2-13
Locknut,5/8-11
SMV
Locknut,
3/8-16
Center
Bracket

CAUTION
Klik Pin
Parking Pin
Figure 2-3: Parking Pin Engaged
Flat Washer,5/8
Figure 2-4: Shipping Bolt
Engaged
Bolt,5/8-11
1P342-0621