Seed Shaft Sensor Schematic - Landoll Brillion SL10 Operator's Manual

ASSEMBLY

Seed Shaft Sensor Schematic

Mount Console with Clutch Control on Tractor.
1. Route Console Harness with 9-Pin Connector to the
Seeder Harness.
2. Attach 3-Pin Power Plug to Tractor.
3. Secure console harness with tie wraps.
4. Route Seeder Harness along front frame of seeder.
Ensure plug labeled Electric Clutch Power is on the
left side.
Console with
Clutch Control
Seeder SensorHarnessSchematic
2-18
Power Plug
Labled
Left Front Seed
Shaft Sensor
Seed Shaft
Sensor
Cavity Plug
2-Pin Shroud
Figure 2-22: Seed Shaft Sensor Schematic
5. On left side seal the plug that says Electric Clutch
using a 2-Pin Shroud and Cavity Plug to protect it
from the environment. See Figure 2-22.
6. Connect plug labeled "Left Front Seed Shaft Sensor"
to the left front Seed Shaft Sensor. Seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
7. Repeat for the right side.
8. Secure all Harnesses and Wires with cable tie and tie
wraps.
Cable Tie
Seeder Harness
Labled
Right Front Seed
Shaft Sensor
3-Pin Tower
Cavity Plug
Seed Shaft
Labled
Right Rear Seed
Shaft Sensor
Labled
Electric Clutch
Power
Labled
Left Rear Seed
Shaft Sensor
1P342-0621
Sensor