Hydraulic Lift System - Landoll Brillion SL10 Operator's Manual

Hydraulic Lift System

The Seeder is equipped with a Hydraulic Lift System to
raise and lower the unit in the field.

Escaping hydraulic fluid can cause serious
personnel injury. Relieve system pressure before
repairing, adjusting, or disconnecting. Wear
proper hand and eye protection when searching
for leaks. Use cardboard instead of hands (See
Figure 3-8.) Keep all components (cylinders,
hoses, fittings, etc.) in good repair.
Figure 3-8: Hydraulic Leak Detection
1. If the Hydraulic System is not filled with oil it should
be purged of air before transporting and field
operations. Carefully hitch the Seeder to the Tractor
and connect the Hydraulic Lift Hoses.
2. Disengage the Transport Locks. See Figure 3-7.
3. Check to make sure the Tractor Hydraulic Reservoir
is full of the manufacturer's recommended oil.
4. Slowly raise the machine until all Lift Cylinders are
fully extended. Lower and raise the unit to verify that
all Cylinders are working throughout the stroke. Fully
extend the Lift Cylinders and continue to hold the
lever until all Cylinder Rod movement stops.
Raise/Lower machine 5 times to purge air from the
system.
5. Do not loosen any Hoses or Fittings. Recheck
Tractor Reservoir to make sure it is within operating
limits.
6. Re-install Transport Locks. See Figure 3-5.
Lift Circuit approximate oil requirement: .4 gallons.
1P342-0621
WARNING
OPERATION
3-7