Center Frame Tires; Fold Anchor And Bolt-On Mount Installation - Landoll 2130 Operator's Manual

3-4 CENTER FRAME TIRES

3-4.1 Install the tire and wheel assemblies on
the center section (See Figure 3-3).

3-5 FOLD ANCHOR AND BOLT-ON MOUNT INSTALLATION

3-5.1 For 17 and 19 shank models, assemble
the fold anchor to the rear cross bar using
u-bolts and 5/8-11 hex lock nuts (See Figure
3-3). Position fold anchor so that the hose
loops point toward the front of the machine.
3-5.2 For 21 - 25 shank models, assemble
two fold anchors to the center frame cross
bars using u-bolts and 5/8-11 hex lock nuts
(See Figure 3-3). Position fold anchors so
that the hose loops point toward the front of
the machine.
3-5.3 Attach base end of 4 x 30 hydraulic cyl-
inders to both sides of fold anchor(s) using
fold pin and 5/16 x 2-1/2 spring slotted pins.
3-5.4 On the 2130-21, 2130-23, and 2130-25
models, attach the bolt-on hinges to the right
and left sides of the center frame using
u-bolts and 3/4-10 hex lock nuts (See Figure
3-3).
IMPORTANT
DO NOT TIGHTEN BOLT-ON HINGES UNTIL
WINGS ARE INSTALLED.
3-7