Warning Lights Installation - Landoll SOIL MASTER II 1200 Series Operator's Manual

3-11 WARNING LIGHTS INSTALLATION

3-11.1 Assemble lights to the light bracket using
1/4 X 1-1/4 hex head cap screws and hex
lock nuts. Insure the wires are in the groove
in the base of the light toward the mounting
surface of the bracket. Assemble one light
for left side and one for right side. The red
light should be to the rear with the amber
light being the outer most light.
3-11.2 Assemble warning light bar and mounting
bracket angle to outer rear of frame as
shown in Figure 3-13. using 1/2-13 x 5-1/2
hex head cap screws and hex lock nuts.
3-11.3 Install the assembled lights to the mount-
ing bracket angle using 1/2-13 x 1-1/2 hex
head cap screws and hex lock nuts (See
Figure 3-13).
NOTE: Make sure lights are positioned for
maximum visibility from the rear.
3-11.4 Install the rear warning light harness be-
tween the lights.
3-11.5 Assemble the harness extension to the
right side of the rear harness.
3-11.6 Install the main harness by starting at the
hitch and routing the harness through the
hose loops to the rear warning light harness.
See wiring diagram as shown in Figure
3-13.
3-11.7 Insure the harnesses are clear of any
moving parts and secure the harnesses with
tie wraps provided.
3-23