Table of Contents
Advertisement
USER'S GUIDE
B
F
RIDGE
ILTERS
C
B
ONFIGURING
RIDGE
Note:
Bridge dial out calls can be initiated through the use of a Known Connect list or through
the use of bridge filters. For a description of bridge dial out through bridge filters, refer to
the section titled
U
CFGEDIT
SING
1.
Select Bridge Filters from the Bridging menu.
2.
Configure any needed protocol definitions. These definitions will be used if you configure any
protocol filters. To configure a protocol definition:
a.
Select to add a protocol definition.
b. Enter a user-defined name for the protocol definition.
c.
Enter the Ethernet type in hex.
d. Enter the LSAP in hex.
3.
Configure source MAC filters.
a.
Select to add a MAC filter.
b. Enter the source MAC address.
c.
Select a distribution list.
3.
Configure destination MAC filters.
a.
Select to add a destination MAC filter.
b. Enter the destination MAC address.
c.
Select a distribution list.
5.
Configure protocol filters.
a.
Select to add a protocol filter.
b. Select a protocol definition Id.
c.
Select a distribution list.
6.
Configure packet data filters.
a.
Select to add a packet data filter.
b. Enter the off set value.
c.
Enter the mask in hex.
d. Enter the data value in hex.
e.
Select a distribution list.
U
M
M
SING
ANAGE
ODE COMMANDS
Manage Mode can be used to complete all of the bridge filter configuration. This section provides
you with the commands available for each bridge filter type.
222
CyberSWITCH
F
ILTERS
Dial Out Using Bridge
Filters.
Advertisement
Table of Contents
Need help?
Do you have a question about the CSX1200 and is the answer not in the manual?