Dräger 8000 IC Instructions For Use Manual page 7

Re-positioning bed end
Can be used at right or left end of bed, as required.
Open front door.
1 Push middle of bed end outwards until it is
released from the groove and
re-position at other end of bed.
Close front door.
Replacing double walls
Left side wall and front door
e.g. when cleaning the incubator
Open front door.
2 Disengage double wall from upper bracket and
fold down.
After cleaning refit the double wall by gently
folding back up until it engages again; close the
front door.
Removable double walls
When larger babies are being treated, their greater heat
production may cause the incubator temperature to rise,
and, if so, the double walls should be removed.
Open front door.
Disengage double walls from upper bracket and remove.
To put back:
Fit double wall to clips provided, raise and
engage in upper bracket.
Close front door.
Bed extension
Required when the rear double wall is not being used
to reduce risk of patient being trapped.
Open front door and pull out bed.
3 Push both ends of bed extension out slightly and
4 click on the rear side of the bed.
Make sure that the bed extension is securely atteched.
Replace bed in incubator.
Do not use bed extension when the rear double wall is in
place as the incubator temperature may be affected.
2
4
3
Preparation
Doors, ports and bed
1
3
7